Foundation Structural Crack Repair

The use of carbon fiber staples is an effective approach to permanently fix poured-wall basement cracks, when used in conjunction with an epoxy injection polymer. The tensile strength of cured epoxy is typically 7000 psi whereas the tensile strength of concrete is in the range of 300 - 700 psi; clearly, the bond strength of epoxy is much greater than that of the foundation wall; making epoxy a good choice for foundation wall structural crack repair.
Strengthening is provided by installing additional reinforcement across the failure plane in combination with the resin injection. At the same Epoxy Injection Crack Repair time the nozzles are positioned and fixed along the entire length of the crack, at approximately 20 cm intervals, with the same material.
The injected epoxy typically cures within 5 hours and bonds the two sides of the crack together in addition to filling the crack through the entire thickness of the foundation wall (typically 8″), thereby sealing the crack permanently because the crack essentially no longer exists; this is the ultimate concrete crack repair.

Epoxy crack injection (also referred to as epoxy injection) is an extremely effective and reliable concrete crack repair method, used exclusively for the repair of poured concrete foundation cracks, for the structural repair of same, to fix basement leaks, and to prevent poured concrete foundation cracks from leaking in the future.
1. Two-component epoxies, which effectively seal a crack and at the same time reinforce the repair area to be actually stronger than the un-repaired concrete area around it. Epoxies are always the preferred material when the structural integrity of the concrete is open to question.

If your pump is working properly then the next most common cause of basement water is the water seeping through a crack or cracks in the wall. If these cracks are not taken care of, it can lead to water and structural damage that will ruin the value and structural integrity of your home.
The kit uses the very same materials our professional contractor customers use to fix concrete cracks in basements, retaining walls, sewers and manholes. 7- Maintain the ports at least for 48 hours to make sure the concrete crack is sealed. The best way to fix concrete wall cracks is to inject them with polyurethane, epoxy works also but it is much harder to inject.

I'm not going to restate that comparison, but'm here to tell you why and how injecting epoxy resin to base cracks just doesn't work in addition to using urethane. Subsequently, the injection ports will be installed, and the crack will be covered over with the epoxy paste.
Generally horizontal cracks are structural cracks usually caused from pressure building up on the opposite side of the wall from either an improper backfill or hydrostatic pressure. Since an epoxy injection is a surface port injection, the injection ports must adhere to the wall surface, directly over the crack, with a very strong bond.
Repair and reinforcement of hairline cracks on PC plate, concrete molding products. Water can leak through cracks or failed joints and often contains corrosive substances and chlorides that breakdown concrete or cause corrosion. The industrial epoxy injection application is injected into the columns bringing back the structural integrity.

Note: The strong epoxy bond is often cited as a negative attribute of epoxy crack injections due to its rigidity. Unfortunately, crack injection is only viable for poured foundations. It is during this step that epoxy resin is injected into the foundation crack. We can take care of both interior and exterior foundation cracks We understand that there are wall crack repair kits sold at your town's home improvement stores, but the materials inside are nowhere near as effective as what we can provide for you.

Leave a Reply

Your email address will not be published. Required fields are marked *